Home > Accessories >

4 Port MCA704/BN 700 MHz Receiver Multicoupler
4 Port MCA704/BN 700 MHz Receiver Multicoupler
 
Our Price: $219.95

Stock Status: Out of Stock


Product Code: 02-531894
Qty:

Email me when Back-In-Stock
Basics
 
MCA704/BN is an active multicoupler designed to distribute antenna signals to four receivers without loss and with high isolation between ports. It is specifically suited for signal intercept stations, both fixed or mobile platforms, 700 MHz service band monitoring, trunk-tracking, etc.. It can be used in any UHF monitoring platform using receivers, scanners or spectrum analyzers.


The MCA704/BN has a mechanical and electrical design construction that will meet any government, military or commercial specification. This unit is designed to give high performance results in any radio monitoring post using multiple intercept receivers. Rugged die-cast aluminum enclosure with a black powder coat finish is standard, olive-drab green (MIl-841OD) is also available on request


The basic use of the receiver multicoupler is to enable several radios , or scanners, to share a common antenna system. The advantage of using a multicoupler in signal monitoring applications were several receivers are used (such as in SIGINT/COMINT), is in the port-to-port isolation of the coupler. Isolation will reduce the possibility of RF interaction between receivers caused by local oscillators, synthesizers, etc. If an external pre-amplifier, receive filter or lightning protection device is used, only one is needed to service several receivers


Both Passive and Active broad-band models as well as narrow-band specialty couplers are manufactured to meet a multitude of HF, 700MHz monitoring applications. Standard port configurations from 2 up to 8 are available. These units are designed to meet government and commercial radio monitoring demands as well as the general hobby market. Active models include broad-band low-noise amplifiers, front-end protection, and, depending on model, input High-Pass or Low-Pass Filters


Choose from one of the two length options for connecting the multicoupler to the scanner:

RG58 Jumper Cable, 3', BNC Male to BNC Male
RG58 Jumper Cable, 6', BNC Male to BNC Male


Accessories...
RG58 Jumper Cable, 6', BNC Male to BNC Male RG58 Jumper Cable, 3', BNC Male to BNC Male
Our Price: $10.95

Add
Our Price: $7.95

Add
RG58 Jumper Cable, 6', BNC Male to BNC Male RG58 Jumper Cable, 3', BNC Male to BNC Male

Share your knowledge of this product with other customers... Be the first to write a review