Home > Accessories > RadioShack Accessories >

SpectrumForce Desk Mount for Two Base Scanners
Desk Mount for Two Base Scanners


 
Alternate Views:


MSRP: $79.95
Our Price: $59.95
You Save: $20.00

Stock Status: In Stock


Product Code: 01-531246
Qty:

Basics
 
This 2-scanner Desk Mount, built with strong sheet-metal, allows you to attractively mount and display one or two base or base/mobile scanners that are approximately 7 to 7.5" wide. You can mount any combination of the following Uniden Bearcat Scanners: BCD996P2,BCD536HP,SDS200, 760, 780, 785, 796, BCT15, BCD996T; GRE PSR400 and PSR600; and a variety of Radio Shack models including the 2053 and 2096 and similar models.

You can also drill holes in the bottom flanges to secure the mounting bracket to a desk or table but the radio weight keeps the unit from sliding in general. You can tilt the radios slightly upward for easy of operation if you desire. The front of the radios protrude approximately 1/2" from the edge of the metal providing a very strong and again, professional, appearance. Simply use the mobile mounting knobs (or bolts can easily be found at a local hardware store) to secure the scanners in place. These brackets are being used at news media assignment desks nationally as well as by hobbyists as a clean and attractive way to present and operate the radios. The brackets have been black-powder-coated to add to the professional look. The mount fits radios of 7.5" perfectly such as the DIN-E radios: The BCT15, BCD996T, PRO-2096, PSR400 and PSR600. But earlier scanners that are 7" wide will require the addition of a few washers or a nut. A three-high version is also available.

The dimensions are as follows: 7.5" wide (inside) by 6 1/8" deep by 6" high; the flange at the bottom is 1" wide.

Average Customer Review: Average Customer Review: 5 of 5 5 of 5 Total Reviews: 2 Write a review.

  1 of 1 people found the following review helpful:
 
5 of 5 Scanner mount October 2, 2015
Reviewer: Dean Gellman from Brooklyn , NY United States  
This is a great mount for your scanners if you have one or more and need to mount them it made of steel and is sturdy and very strong

Was this review helpful to you?

  5 of 5 people found the following review helpful:
 
5 of 5 Nice and solid February 22, 2011
Reviewer: Dave from Irvine, CA United States  
I found this mount to be very stable, made from heavy metal with a textured black finish.   It holds the radios securely and feels very solid with the radios in it.  I put some non-slip pads under the flanges to keep it from sliding around on a smooth service, and weight of the radios makes it all very stable.   The radios are easy to tilt up and own for viewing angle, although I periodically need to retighten the radio mounting screws after the radios have been tilted a few time.  However, that would be true for just about any mount or bracket.   Overall, I'm very happy with this one.

Was this review helpful to you?