Home > Accessories > Antenna Accessories >

16 Port MCA216M VHF/UHF Receiver Multicoupler
MCA216M VHF/UHF Receiver Multicoupler


 
Our Price: $895.00

Stock Status: Out of Stock


Product Code: 02-532023
Qty:

Email me when Back-In-Stock
Basics
 
MCA216M is an active multicoupler designed to distribute VHF/UHF antenna signals to sixteen (16) VHF/UHF receivers simultaneously without loss of signal level and with high isolation between ports to minimize interaction between output devices. It is specifically suited for larger signal intercept and VHF/UHF monitoring stations, both fixed or mobile platforms. It can be used in any monitoring post using receivers, scanners or spectrum analyzers.

MCA216M has a mechanical and electrical design construction that will meet any government, military or commercial specification. A very robust circuit design with premium components and a RF Power limited front-end with dual amplifier stages. This design provides additional protection from very strong RF levels from nearby transmitters, or in cases where transmit and receive antennas are located in close proximity to each other. It also provide protection from electrostatic discharge (ESD) introduced on to the antenna system originating from wind driven ESD build-up and to those ESD from nearby lightning storms. Additional circuitry balances output levels to each port within 1 dB. This unit is designed to give high performance results in any radio monitoring post using multiple intercept receivers. Rugged die-cast aluminum enclosure with a black powder coat finish.

Input is an "N" Female Connector, outputs are BNC Female.
Specifications:
Frequency Range: 25 MHz to 1 GHz. 16-Ports
Nominal Impedance: 50 ohm
Port-To-Port isolation (min): 22 dB
Return Loss (all ports): > 20 dB
P1dB = 17 dBm (output) 3OIP = 32 dBm (output
Coupler Gain/Loss: +2 dB to -1 dB (max) over frequency range
RF Connectors: N (input) BNC (outputs)
Mechanical: 8.50 X 5.75 X 1.50 inches (L.W.H)
Case: Die cast Aluminum, Black powder coating (standard)
DC Power Connector: 2.1/5.5mm coaxial (standard)
DC Power Requirements: +12VDC (nominal) @ 150 mA

Share your knowledge of this product with other customers... Be the first to write a review